Fujitsu MAU3147RC Product/Maintenance Manual page 7

Important Alert Messages
The important alert messages in this manual are as follows:
Task
Installation Damage
Never remove any labels from the drive or deface them in any way.
High temperature
To prevent injury, never touch the drive while it is hot. The DE and LSI
become hot during operation and remain hot immediately after turning off
the power.
Damage
1. When dismounting the drive which is mounted on the
system while power is supplied to it.
• The spindle motor can be stopped by a START/STOP command. It
takes about 30 seconds for the spindle motor to stop completely.
• Then, dismount the drive using the drive mounting/dismounting
mechanism, etc. of the system. If the drive is dismounted while the
spindle motor is running, special care is required to avoid excessive
vibration or shock to the drive. It is recommended to stop the
operation once the connector breaks off contact and wait until the
spindle motor stops (about 30 seconds) before dismount the drive.
• When storing or transporting the drive, put it in the antistatic bag
(refer to Section 5.1).
C141-E222
Important Alert Items
A hazardous situation could result in minor or moderate personal injury if the
user does not perform the procedure correctly. Also, damage to the product
or other property, may occur if the user does not perform the procedure
correctly.
Alert message Page
4-4
5-1, 5-10
5-10
iii