Fujitsu MAU3147RC Product/Maintenance Manual page 61

(2) Caching parameters
The following parameters are used to optimize HDD Read-Ahead caching operations under the
system environments. Refer to Chapter 3 "Data Buffer Management" of the Serial Attached SCSI
Interface Specifications for further details.
• IC:
• RCD:
• WCE:
• MS:
• DISC:
• Number of blocks for which prefetch is suppressed
• Minimum prefetch
• Maximum prefetch
• Number of blocks with maximum prefetch restrictions
• Number of segments
Notes:
1. When Read-Ahead caching operations are disabled by the caching parameter, these
parameter settings have no meaning except write cache feature.
2. Determine the parameters in consideration of how the system accesses the disk. When the
access form is not determined uniquely because of the processing method, the parameters
can be re-set actively.
3. For sequential access, the effective access rate can be increased by enabling Read-Ahead
caching operations and Write Cache feature.
(3) Control mode parameters
The following parameters are used to control the tagged queuing and error logging.
a. Control mode parameters
• Queue algorithm modifier
• QErr:
• DQue:
C141-E222
5.4 Checking Operation after Installation and Preparing the HDD for Use
Parameter
Initiator control
Disabling Read-Ahead caching operations
Write Cache Enable
Specifying the multipliers of "minimum
prefetch" and "maximum prefetch" parameters
Prefetch operation after track switching during
prefetching
Parameter
Resume or abort remaining suspended
commands after sense pending state
Disabling tagged command queuing
Default value
0 (Drive-specific
control (page
cache))
0 (enabled)
1 (enabled)
0 (Specifying
absolute value)
1 (enabled)
X'FFFF'
X'0000'
X' XXXX'
(1 cache segment)
X'FFFF'
X'08'
Default value
0 (Execution sequence of
read/write commands is
optimized.)
0 (command is resumed)
0 (enabled)
5-9