Table of Contents
Advertisement
Some displays are not seen
during the operation.
PIN code dialog box appears at start-up.
The Remote Control does not work.
WARNING :
High voltages are used to operate this projector. Do not attempt to open the cabinet.
If problems still persist after following all operating instructions, contact the dealer where you purchased the
projector or the service center. Give the model number and explain about the problem. We will advise you
how to obtain service.
The CE Mark is a Directive
conformity mark of the European
Community (EC).
Pixelworks ICs used.
–Check the Display function. (See page 42.)
–PIN code lock is being set. Input a PIN code (1234 or
numbers you have set). (See pages 19 and 48.)
–Check the batteries.
–Make sure no obstruction is between the projector and
remote control.
–Make sure you are not too far from the projector when using
the remote control. Maximum operating range is 16.4' (5m).
–Make sure the code of the remote control is conformed to
the projector. (See page 47.)
–Unlock Key lock for the remote control in the Key lock
function. (See page 47.)
This symbol on the nameplate means the product
is Listed by Underwriters Laboratories Inc. It is
designed and manufactured to meet rigid U.L.
safety standards against risk of fire, casualty and
electrical hazards.
Appendix
57
Advertisement
Table of Contents
