Char-Broil 466720509 Product Manual page 22

Burner, Firebox and Control Knobs
11
Place burner assembly into firebox. Fasten the burner assembly to the firebox using 5x15 fiber washers and #10-24 x ½"
machine screws. Insert two #10-24x1-1/4" screws from outer firebox, then fasten with two #10-24 flange nuts and 5x15
fiber washers from inner. Repeat on the other side (A).
Place firebox onto upper firebox supports. Make sure the venturi tubes are located underneath heat shield. Make sure
venturi tubes are correctly engaged. If burner is not leveled from left to right, adjust the two screws attaching valve to
control panel. Attach ignitor wire to ignitor (B).
Attach firebox with #10-24x1/2" screws, 5x15 fiber washers and #10-24 flange nuts (C).
Push control knobs onto valve stems (C).
Burner Assembly
A
#10-24x1-1/4"
Machine Screw
5x15 Fiber Washer
#10-24X1/2"
Machine Screw
#10-24X1/2"
Machine Screw
5x15
Fiber Washer
Control Knob
22
Firebox
5x15 Fiber washer
#10-24
Flange nut
Heat Shield, F/ Tank
C
5x15
#10-24X1/2"
Fiber Washer
Machine Screw
Qty. 10
Qty. 6
B
Valve
Venturi tube
Make sure the Venturi tubes are located
underneath Heat Shield
#10-24 Flange nut
#10-24
Flange Nut
Qty. 8
#10-24x1-1/4"
Machine Screw
Qty. 4
Ignitor wire