Network Settings - Intelbras TIP 300 Installation Manual

4.3. Network settings

Static IP (fixed)
1. Press Menu, use the
2. Use the
3. Use the alphanumeric keypad to enter the password (factory default: admin)
and press
4. Use the
5. Use the
6. Use the
7. Use the alphanumeric keypad to enter the number of the IP address and press
8. If the address entered is not valid, the following warning will appear on the
display: "Invalid IP address!";
9. If the address does not belong to the mask of the sub-network and the default
gateway, these must also be configured.
Note: press
settings will be applied.
PPPoE
1. Press Menu , use the
2. Use the
3. Use the alphanumeric keypad to enter the password (factory default: admin)
and press
4. Use the
5. Use the
6. Use the
7. Use the alphanumeric keypad to enter the PPPoE user ;
8. Use the
and press
Note: press
settings will be applied.
After confirmation, it will be possible to access the Internet. Continue with the
following configuration.
42
keys to select Settings and press
keys to select Advanced Settings and press
;
keys to select Network and press
keys to select WAN Port and press
keys to select Static IP Client and press
, or wait 1 minute and the device will reinitialize and the new
keys to select Settings and press
keys to select Advanced settings and press
;
keys to select Network and press
keys to select WAN Port and press
keys to select PPPoE IP Client and press
keys to select PPPoE PWD, enter the password of the PPPoE user,
.
or wait 1 minute and the device will reinitialize and the new
;
;
;
;
;
;
;
;
;
;
;