Toro LT3340 Operator's Manual page 32

Restoring the Transmission Pump
1. Chock the front wheels.
2. Raise the platform forward; refer to
Platform (page 37).
3. Use an 8 mm (5/16 inch) hex key to rotate
the 2 socket head plugs for the transmission
pump-relief valves clockwise 3 turns
Figure 36
1. Socket head plugs (transmission pump-relief valves)
4. Torque the 2 socket head plugs to 81 N∙m (59.7
ft-lb).
Restoring the Brakes
1. Remove the bolt 12 x 40 mm and washer 12
mm from the hole at the center of the motor end
Raising the
plate
(Figure 36).
1. Front wheel motor
2. Hex plug
2. Install the hex plug into the motor end plate
(Figure
g328252
1. Hex plug
3. Repeat steps
other side of the machine.
4. Remove the wheel chocks.
5. Disconnect the tow bar.
Note:
for operation.
6. Stow the 2 bolts 12 x 40 mm and 2 washers 12
mm stored in the platform support rails
38).
32
(Figure 37).
Figure 37
3. Washer 12 mm
4. Bolt 12 x 40 mm
38).
Figure 38
1 through 2 for the brake at the
The transmission and brakes are ready
g014451
g292377
(Figure