Advertisement
Install the Device/ 设备安装
A Install the SD card/ 安装 SD 卡
1
Use a Phillips screwdriver to remove the left ear cover, insert the SD card.
使用十字螺丝刀将球机左耳盖卸下，插入 SD 卡。
B Pole-Mount/ 立杆抱装
2
Unfasten the three loops and put the loops through the installation holes on the pole-mount bracket. Thread
the cables through the pole-mount bracket and wall-mount bracket. Place the loops around the pole and
fasten the loops to fix the pole-mount bracket on the pole.
将 3 个抱箍拧开，穿过抱装支架的安装孔。将需要与球机尾线对接的线缆穿过抱装支架和壁装支架。将抱箍环绕在柱杆上，
拧紧抱箍，将抱装支架固定在柱杆上。
HUAWEI
CAUTION/ 注意
• When the camera is not connected or
cannot be connected to a video surveillance
platform for a long time, you are advised
to disable video buffering of the camera to
increase the service life of the SD card.
若摄像机长时间无法接通平台或者不对接平
台使用，建议手动关闭摄像机的平台离线缓
存补录功能，以提高SD卡的使用寿命。
NOTE/ 说明
Ensure that the connection of the network cable is not parallel to the
connections of other cables. If the connections of all cables are parallel to each
other, you may have difficulty tucking the cables into the wall-mount bracket.
在对线缆进行防水和绝缘处理时，将网线和其他线缆的连接处相互错开，以方便穿线。
Apply the water-proof tape to the connection of the wall-mount bracket,
connector, and dome camera. For details, please refer to "Connect cables".
对壁装支架、转接头和球机的连接处使用防水胶带进行防水处理。详细操作请参见"连
接线缆"章节。
B Pole-Mount/ 立杆抱装
1
Align the screw holes on the wall-mount bracket with the screw holes on the pole-mount bracket, tighten the
screws.
将壁装支架上的螺孔与抱装支架上相应的螺孔对齐，拧紧螺钉。
3
Tighten the connector into the joint of the wall-mount bracket, use a
screw clockwise to fix the quick connector and bracket. Use safety ropes to connect the camera and conversion
adapter. Connect the cables to the tail cables of the dome camera, apply the PVC insulation tape and water-
proof tape to the cables, and tuck the cables into the wall-mount bracket. Connect the dome camera to the
connector, align the screw holes on the flange with the screw holes on the connector, and use a allen wrench
to tighten the screws.
将转接头拧入壁装支架连接口，使用十字螺丝刀顺时针旋转紧定螺钉，紧固快装转接头和支架。使用安全绳连接摄像机和
转接头。将线缆与球机的尾线连接，并对线缆进行防水和绝缘处理，并将线缆引入到支架中。将球机嵌入转接头中，球机
法兰上的螺孔和转接头上的螺孔对齐，使用内六角扳手拧紧螺钉。
Phillips screwdriver
to screw the set
Set screw
紧定螺钉
1
2
4
3
Advertisement
