Ravanson PM-7500S User Manual page 17

•
The air-conditioner must always be in the upright position on an even surface;
•
Do not put near a bathtub, washbasin or other wet or damp surfaces.
Store the device at least 50 cm from the wall, curtains, drapes and sources of heat to ensure appropriate heat
circulation.
IV. INSTALLING THE DEVICE USING THE WINDOW KIT
PLEASE NOTE!
The kit is designated solely for installing at the sliding windows or doors.
Do not use the kit for installing in basement windows.
Step 1
Check the exact dimensions of the window and the kit of accessories for window installation. If the slide for
window regulation is too long, cut it using the appropriate tools. If it is too short, you can buy a longer slide in
DIY stores.
Step 2
Connect the draining hose with the connector (Fig. A). Connect the hose to the air discharge at the rear (Fig. B).
Turn it in by rotating counterclockwise.
Figure A
Draining hose
Step 3
Insert the hose connector into the window adapter (Fig. C). Adjust the adapter to the window width (vertically
or horizontally) and then tighten the screw to prevent the adapter displacement (Fig. D). Ensure the adapter
matches the window and stays in place. Close the window so as the adapter remains in the slot between the
window and the frame or the sill (Fig. E).
Hose connector
17