Recommended Equipment; Removing And Installing The Shroud And Covers (Rst90Tf / Rst90Tfl / Rst90Tfy) - Yamaha RST90G Owner's Manual

Periodic maintenance and adjustment
1
1. Hexagon wrench cover
2. Hexagon wrench
3. Tool kit
4. Strap
ESU14231

Recommended equipment

It is good practice to carry the spare parts
and other necessary equipment with you
while riding the snowmobile so that minor re-
pairs can be done if necessary. The following
should be carried at all times:
 Flashlight
 Roll of plastic tape
 Steel wire
 Tow rope
 V-belt
 Light bulbs
When you start out for a long distance trip,
extra fuel should be carried as well.
ESU14900
Removing and installing the
shroud and covers (RST90TF /
RST90TFL / RST90TFY)
EWS00092
WARNING
Be sure shroud and covers are secured
before operation. A loose shroud or cover
could move and cause loss of control.
60
2
3 4
Shroud
To remove the shroud
Loosen the fasteners, slowly raise the
shroud, and then unhook the shroud from the
shroud stay.
1
1. Fastener
2. Shroud
3. Shroud stay
To install the shroud
Hook the end of the shroud onto the shroud
stay, slowly lower it to the original position,
and then tighten the fasteners.
1. Shroud stay
Left and right side covers
To remove a side cover
1. Remove the shroud. (See the above pro-
cedure.)
2. Loosen the fasteners, pull outward on
the areas shown, and then slide the side
cover forward to remove it.
2
3