Replacing A Fuse - Yamaha RST90G Owner's Manual

Batteries produce explosive gases. Keep
sparks, flame, cigarettes, etc. away. Venti-
late when charging or using in an enclosed
space. Always shield your eyes when
working near batteries.
KEEP OUT OF THE REACH OF CHILDREN.
Charge or have a Yamaha dealer charge the
battery as soon as possible if it seems to
have discharged. Keep in mind that the bat-
tery tends to discharge more quickly if the
snowmobile is equipped with electrical ac-
cessories.
EWS00611
WARNING
 Never smoke around the battery while it
is being charged. Sparks may ignite the
hydrogen gas created by the battery.
 Disconnect the negative lead first, then
the positive lead from the battery.
 Connect the positive lead first, then the
negative lead to the battery when install-
ing the battery.
 Never connect the battery to or discon-
nect it from the snowmobile while it is
being charged. Sparks may ignite the
hydrogen gas created by the battery.
 Make sure that the battery terminals are
tight.
ECS00844
NOTICE
 To charge a VRLA (Valve Regulated
Lead Acid) battery, a special (constant-
voltage) battery charger is required. Us-
ing a conventional battery charger will
damage the battery.
 Do not charge the battery quickly.
Periodic maintenance and adjustment
ESU14950

Replacing a fuse

EWS00551
WARNING
Be sure to use the specified fuse. A wrong
fuse could cause electrical system dam-
age or A FIRE HAZARD.
ECS00632
NOTICE
Be sure to turn the main switch to the off
position and disconnect the negative bat-
tery lead to prevent accidental short-cir-
cuiting.
RST90TF / RST90TFL / RST90TFY
The main fuse, the EPS fuse, and the fuel in-
jection system fuse are located under the air
filter case. The fuse box, which contains the
fuses for the individual circuits, is located be-
hind the right side cover.
1. Remove the shroud, the left and right
side covers, and the top cover. (See
page 60 for removal procedures.)
2. Remove the headlight unit bolt and the
windshield stay bolts on each side of the
snowmobile.
2
1. Headlight unit bolt
2. Windshield stay bolt
3. Unhook the headlight unit as shown,
then lift it up and move it rearward, away
from the air filter case cover. NOTICE:
1
97