Adjusting The Headlight Beams - Yamaha RST90G Owner's Manual

1
1. Do not touch the glass part of the bulb.
Bulb type:
Halogen bulb
8. Install the bulb holder cover, and then
connect the headlight coupler.
9. Install the headlight unit, making sure to
fit the slots on its bottom onto the projec-
tions on its stay.
1
2
1. Slot
2. Projection
10. Fit the weatherstrip on the headlight unit
into the recess in the top of the air filter
case cover.
Periodic maintenance and adjustment
1. Weatherstrip
11. Install the headlight unit bolts and wind-
shield stay bolts, and then tighten them
to their specified torques.
Tightening torques:
Headlight unit bolt:
3.0 Nm (0.30 m·kgf, 2.2 ft·lbf)
Windshield stay bolt:
14 Nm (1.4 m·kgf, 10 ft·lbf)
12. Install the top cover and the shroud.
ESU14151

Adjusting the headlight beams

RST90TF / RST90TFL / RST90TFY
1. Remove the top cover. (See page 60 for
removal procedures.)
2. Use a Phillips screwdriver to turn the
headlight beam adjusting screw and ad-
just the headlight beams. To lower the
headlight beams, turn the headlight
beam adjusting screw in direction (a). To
raise the headlight beams, turn the head-
light beam adjusting screw in direction
(b).
1
95