A
(注意) 押えが針板に密着した状態で、押え棒抱き
B
すきま
Clearance
– 4 –
9) ミシンの面板を外して押えを下げ、引き上げ板
を下方に押し下げた状態にして、ドライバー
A でソレノイド軸を左側に回転させ、六角棒
スパナ B で抱きねじを締めます。この時、ソ
レノイドは矢印の方向へ押し付けた状態でセッ
トします。
裏面と引き上げ板先端にすきまがあること
を確認してください。
9) Remove the face plate of the machine, put lifting
lever in the state of pressing down, turn solenoid
shaft to the left with screwdriver A, and tighten
screw with hexagonal spanner B. At this time,
set the solenoid in the state that it is pressed in the
direction of the arrow.
(Caution) In the state that the presser foot comes
in close contact with the throat plate,
make sure that a clearance is provided
between the back face of presser bar
guide bracket and lifting lever .
10) AK 装置を使用する場合は、テーブルの頭部支え
棒を取り外してご使用ください。
10) Remove the head support bar on the table when
using AK device.