Page 1
TUMBLE DRYER MODEL: ED-H9151C(WH) Owner’s Manual Please read this manual carefully before operating your set. Retain it for future reference. Record model number and serial number of the set. See the label attached on the set and quote this information to your dealer when you require service.
Page 2
REMOVE ALL PACKING MATERIALS FROM THIS PRODUCT BEFORE USING IT. THIS APPLIANCE MUST BE INSTALLED IN LEVEL. PLEASE ENSURE THE ELECTRICITY SUPPLY TO THIS APPLIANCE IS DISCONNECTED BEFORE INSTALLING. Please read this instruction carefully. It is advisable to keep this instruction manual in a safe place for future reference.
1. INSTALLATION Position the tumble dryer so that the plug remains accessible after installation. Do not block the back of the dryer, as this will impair the working of the dryer. Leave a space of 10cm between the rear of the tumble dryer to the wall.
TRANSPORT Move the dryer cautiously. Do not grasp any salient parts of dryer when moving. The dryer door cannot be used as the handle for delivery. INSTALLATION POSITION 1. It is recommended to position close next to the washing machine for your convenience.
2. SAFETY PRECAUTIONS Install or store the appliance where it will not Keep area around the exhaust opening be direct exposed to water or sun, this may and adjacent surrounding areas free from cause permanent damage or malfunction of the accumulation of lint, dust and dirt. An the appliance.
Page 6
Please do not operate the appliance Do not dry laundry that contain rubber, plastic without the lint filter as it might cause the or similar materials such as padded bras, damage to appliance. tennis shoes, galoshes, bath mats, rugs, bibs, baby pants, raincoat, plastic bags or pillows that may cause melt or burn.
Page 7
3. PREPARATION Please pay attention to use the appliance if the labels inside the garments cannot be dried or contain the symbols as follows: 1. To avoid the need to iron easy-care polyester / cotton items, it is better to only dry small loads (half fill drum) with small and large articles together.
4. PRODUCT DESCRIPTION 1. Top Board 2. Control Panel 3. Door 4. Plinth Opening Slot 5. Plinth 6. Adjustable Feet 7. Plinth Cover 8. Lint Filter 9. Water Container 10. Ventilation Grills 4.1 CONTROL PANEL DESCRIPTIONS 1. Program Knob Turn the program knob to select the drying program. 2.
Page 9
4.2 INDICATOR AND ADDITIONAL FUNCTIONS Delay Timer You can delay the start time of the programme by selecting the 3-hour, 6-hour or 9-hour option. You can activate the desired delay time by pressing the Start/Pause button. When the time is up, the selected programme will start automatically. During the delay time, options compatible with the programme can be activated / deactivated.
Page 10
Anti-Crease If you select the "Anti-Crease" option and do not open the door of the dryer at the end of the programme, the 1-hour anti-crease phase will extend to 2 hours. After selecting the Anti-crease option, you will hear an audible warning. You can press the same button again to cancel the option.
4.3 DISPLAY SYMBOLS: Water tank warning indicator Lint filter cleaning warning indicator Condenser cleaning warning indicator Water Container Full Dryer will stop operate once the link filter is full. Please empty the water container when the “ ” light is on. Lint Filter Full Dryer will stop operate once the link filter is full.
5.0 PROGRAMME SETTING Cotton Extra Dry This programme dries thick and multi-layer fabrics, such as cotton towels, bedsheets, pillowcases, bathrobes, at a high temperature to allow you to place them in a closet. Cotton Cupboard Dry This programme dries cotton pyjamas, underwear, table cloths etc. to allow you to place them in a closet.
Page 13
Time Programmes To reach the required drying level at a low temperature, you can use the timed programmes of 10 minutes, 30 minutes and 60 minutes. Regardless of the drying level, the programme stops at the desired time. Refresh This programme provides ventilation for 10 minutes without applying heat to help fresh up your garments.
5.2 OPERATION 1. Press On/Off button to activate the dryer. 2. Open the door and insert the laundry. Close the door once all the laundry had been inserted. 3. Turn the program knob and select the right program to dry the laundry. (Please refer to 5.1 program table) 4.
6.0 CLEANING AND MAINTENANCE Do not use industrial chemicals to clean your dryer. Do not use a dryer that has been cleaned with industrial chemicals. 6.1 CLEANING THE LINT FILTER 1. Pull the lint filter upwards and away from the appliance. 2.
6.2 EMPTYING THE WATER TANK 1. Pull the drawer cover and carefully take out the tank. 2. Empty the water in the tank. 3. Refit the water tank. NOTE: Never remove the water tank when the programme is running. The water condensed in the water tank is not suitable for human consumption.
5. Fully insert the condenser into its seat and lock the 2 locks. 6. Close the plinth cover NOTE: Do not operate the dryer without the air condenser. 6.4 CLEANING THE HUMIDITY SENSOR Inside the dryer, there are humidity sensors that detect whether the laundry is dry or not. To clean the sensors: 1.
6.5 CLEANING THE INNER SURFACE OF THE LOADING DOOR Clean the inner surface of the loading door after each time use. Open the loading door of the dryer and clean all of the inner surfaces and the gasket with a soft, damp cloth. 6.6 CLEANING THE CABINET AND DRUM Use a soft damp cloth wipe when cleaning the cabinet and drum.
7.0 TROUBLESHOOTING If the laundry is not dried after normal drying program. 1. Check that the lint filter has been cleaned. A blocked filter will restrict the airflow. 2. If the cut-out continues to operate after checking the above points, you should contact the after sales service centre.
7.1 ERROR CODE Error code Action Empty the water tank. If problem does not solved, please contact technician for service. Please contact technician for service. Please contact technician for service. Please contact technician for service. There may be voltage fluctuation in mains. Wait until voltage is appropriate for working range then restart again.
8.0 TECHNICAL SPECIFICATION Model ED-H9151C(WH) Drying Capacity 9.0KG Voltage 220–240V~ Frequency 50Hz Rated Power 2,700W Maximum Current Product Dimension (mm) 596 (W) x 845 (H) x 609 (D) Carton Dimension (mm) 655 (W) x 890 (H) x 662 (D) Net / Gross Weight 38.5 KGS / 41.0 KGS...
Page 22
The rear of the dryer gets hot during use. Position the dryer so that the back is not accessible while in operation, but ensure that the sides have a space available to allow airflow. The special mains cable and plug assembly must only be replaced with a genuine part from the manufacturer or authorized service centre.
Need help?
Do you have a question about the ED-H9151C and is the answer not in the manual?
Questions and answers