Sony BETACAM SX DNW-A30 Maintenance Manual page 15

. Attachment of inner rails
(4) Pull out the inner rails from the two intermediate rails.
(5) While pressing the stopper of the inner rail in the
direction of the arrow A in the figure, pull out it in the
direction of the arrow B. (Pull out the other inner rail
in the same way.)
Intermediate rail
Inner rail
Stopper
B
(6) Remove the ten screws from both sides (left and right)
of the unit shown in the figure.
(7) Attach the two inner rails to both sides (left and right)
of the unit using the screws removed in the procedure
(6).
Tighting torque: 1.2 N . m {12.2 kgf . cm}
n
Be sure to attach the inner rail using the screws (B4 x
6). If other screws are used, a failure occurs in the
operation of the unit.
Inner rail
B4 x 6
DNW-A30/A30P
DNW-30/30P
http://getMANUAL.com
Outer rail
A
B4 x 6
Inner rail
. Attachment of rack angles (handles)
(8) Remove the four screws (B4 x 6) in the figure from
both sides (left and right) of the unit.
B4 x 6
B4 x 6
n
Keep these screws (B4 x 6) that are removed in the
procedure (8) carefully.
Be sure to use these screws when directly attaching the
side panels by screws after removing the rack angles.
If the rack angle fixing screws (PSW4 x 16) are used by
mistake, a failure occurs in the operation of the unit
because they are longer than the (B4 x 6) screws.
(9) Attach the two rack angles to both sides (left and right)
of the unit using the four screws (PSW 4 x 16)
supplied with the rack mount kit.
Tighting torque: 1.2 N . m {12.2 kgf . cm}
PSW4 x 16
Rack angle
PSW4 X 16
1-6. Rack Mounting
B4 x 6
B4 x 6
Rack angle
PSW4 x 16
1-5