Download Print this page

Lakes Bathrooms SS10 Installation & Maintenance Instructions Manual

Single panel bathscreens

Advertisement

Quick Links

SINGLE PANEL BATHSCREENS
Installation & Maintenance Instructions
Models Covered :
SS10 : CURVED SCREEN
SS30 : SCULPTED SCREEN
SS50 : SQUARE SCREEN
SS11 : CURVED SCREEN
SS33 : SCULPTED SCREEN
SS55 : SQUARE SCREEN
+ TOWEL RAIL
+ TOWEL RAIL
+TOWEL RAIL
Rev 02.12
Rev 01/19

Advertisement

loading

Summary of Contents for Lakes Bathrooms SS10

  • Page 1 SINGLE PANEL BATHSCREENS Installation & Maintenance Instructions Models Covered : SS10 : CURVED SCREEN SS30 : SCULPTED SCREEN SS50 : SQUARE SCREEN SS11 : CURVED SCREEN SS33 : SCULPTED SCREEN SS55 : SQUARE SCREEN + TOWEL RAIL + TOWEL RAIL +TOWEL RAIL Rev 02.12...
  • Page 2: Important Notes

    However should maintenance be required it should be carried out by a competent person with reference to these instructions. Before any work is carried out the root cause of the problem must be identified. Lakes Bathrooms service engineers are available if necessary to consult / carry out remedial work. Call Lakes Bathrooms HELPLINE.
  • Page 3: Supplied Parts

    SUPPLIED PARTS : Screen Sub Assembly Comprising: Hinge Rail Hinge Rail (Wall side) Hinge Bearing (bonded to (2x) screen glass) Top Hinge Bottom Hinge Bracket Bracket M4 x 30 long Pan Head Pozi Drive Screw (4x) Screen Glass Hinge Seal (Curved shown) (2x) 5mm x 60 long Countersunk...
  • Page 4 Standard Size Adjustment (A) Tools Required SS10 / SS11 800 to 825mm Dia 8mm SS30 / SS33 860 to 885mm Tile / Masonry SS50 / SS55 800 to 825mm Drill Bit Spirit Level (with vertical ‘bubble’) Tape Measure Pencil Dia 3mm...
  • Page 5 Select appropriate top cap (left/right) & fit to top of Wall Rail 1. Push support & basepad onto bottom edge of glass toward outer end of screen. 2. Carefully lift screen into position & push into wall profile. Check bottom hinge bracket is sitting on bath rim &...
  • Page 6 With ‘drip strip’ to inside, select appropriate hand seal end caps (left /right). 4a. Apply clear silicone sealant to hinge end cap & push into seal. 4b. Keeping hinge end cap against bottom hinge, push seal upward onto bottom edge of glass (Note : seal may be‘wetted’...
  • Page 7: Basic Troubleshooting

    / bottom hinge ONLY. Water / moisture appearing outside this area (ie under the bathtub or at floor level) is normally due to incorrect bathtub installation / sealing. Lakes Bathrooms Ltd Lakes Bathrooms Ltd Service : Northern Ireland...

This manual is also suitable for:

Ss30Ss50Ss11Ss33Ss55