Advertisement
B
2
4c.
With 'drip strip' to inside, select appropriate hand seal end caps (left /right).
4a. Apply clear silicone sealant to hinge end cap & push into seal.
4b. Keeping hinge end cap against bottom hinge, push seal upward onto bottom edge
of glass (Note : seal may be'wetted' to ease fitting).
4c. Apply clear silicone sealant to outer end cap & push into seal & upto glass edge.
Wipe off excess sealant with a damp cloth.
C
Towel Rail Models
Decorative
Washer
Towel Rail
A) Tighten screw fully into internal boss.
B) Fit rubber washer & sleeve onto screw
C) Pass screw through glass, fit rubber washer & decorative washer
onto screw then tighten screw into towel rail by turning internal
boss until rail is secure. Additional tightening can be achieved by inserting (dia 2,8mm)
drill bit or 2,5mm hexagon wrench (allen key) into the internal boss cross hole.
4b.
Sleeve
Rubber
Washer
4a.
Note : Towel Rail used on S
a different style (straight bar),
but is affixed in the same way.
Screw
S55
is
Internal
Boss
Rubber
Washer
Advertisement
