Bosch WVH30547EP Instruction Manual And Installation Instructions page 33

Faults
Spin result not satisfac-
tory.
Laundry wet/too damp.
Spin cycle activated sev-
eral times.
Compartment M is not
rinsed out completely.
Odour formation in the
washer dryer.
Status display Ålights
up. Foam may come out
of the detergent drawer.
Excessive noise, vibra-
tions and "wandering"
during spin cycle.
Display panel/indicator
lights do not function
while the appliance is run-
ning.
The programme duration
changes during the wash
cycle.
Detergent residue on the
washing
Spin noise during the dry-
ing phase.
Different coloured fluff
from the previous drying
cycle is deposited on the
laundry during the subse-
quent wash cycle.
Water inlet noise during
the drying phase, the tap
symbol flashes during the
drying phase.
Cause/Remedy
Not a fault – unbalanced load detection system has stopped the spin cycle,
■
washing unevenly distributed. Distribute small and large items of washing
in the drum.
Too low speed selected?
■
Not a fault – unbalanced load detection system adjusts imbalance.
Remove the insert. Clean the detergent drawer and insert it ~ Page 28
Run the Retirar pelusas/fios (Fluff Clean) 90°C programme without laun-
■
dry.
Use standard detergents.
■
Too much detergent used?
Mix 1 tablespoon of fabric softener with ½ litre of water and pour into
■
dispenser II. (Not for outdoor, sports and down-filled textiles!)
Reduce detergent dosage for the next wash cycle.
■
Use commercially available low foam detergent and care products which
■
are suitable for washer dryers.
Appliance aligned? Align the appliance ~ Page 42
■
Are the appliance feet fixed? Secure appliance feet ~ Page 42
■
Transportation safety devices removed? Remove the transportation bolts
■
~ Page 39
Power failure?
■
Fuse tripped? Switch on/replace fuse.
■
If the fault occurs repeatedly, call the customer service ~ Page 35
■
Not a fault – unbalanced load detection system adjusts imbalance.
■
Not a fault – foam detection function active. Additional rinse cycle.
■
Occasionally phosphate-free detergents contain water-insoluble residues.
■
Select O (Rinse) or brush items when the laundry is dry.
■
This is an innovative process known as thermal spinning used to reduce
■
energy consumption during the drying phase.
Run the Retirar pelusas/fios (Fluff Clean) cold programme without laundry to
remove fluff which has collected in the washer drum during the drying phase.
The washer dryer runs a self-cleaning cycle to remove fluff which was deposited
by the laundry during the drying phase. This requires a little water. Therefore,
the tap must be turned on even during the drying phase.
Faults and what to do about them
en
33