Important Note To Installer; Installation Fl Ow Chart - Samsung WF393BTPA Series User Manual

IMPORTANT NOTE TO INSTALLER

Please read the following instructions carefully before installing the washer.
These instructions should be retained for future reference.
We recommend you hire a professional to install this washer.
Installation fl ow chart
Selecting a
location
Please
check again
before
steps.
Yes
STEP 1
Removing the Shipping Bolts
Before using your washer, you must remove all shipping bolts from the
back of the unit.
1. Loosen all the bolts with the supplied wrench.
2. Slide the bolt and spacer up and remove the bolt with the spacer
through the hole in the rear wall of your washer. Repeat for each
bolt.
3. Cover the holes with the supplied Bolt Hole Covers (See page 13).
4. Keep the shipping bolts and spacers for future use.
STEP 2
Selecting a Location
Before you install your washer, make sure the location:
•
•
•
•
•
•
•
WF395BTPA-03145B-02_EN_20120829.indd Sec2:17 WF395BTPA-03145B-02_EN_20120829.indd Sec2:17
Removing the shipping
bolts (*Drum only)
Powering your washing
Adjusting the
levelling feet
Does
your washer
have excess vibration
No
or noise?
Has a hard, level surface
Is away from direct sunlight
Has adequate ventilation
Will not freeze (tempuratures are never below 32 °F or 0 °C).
Is away from heat sources such as oil or gas
Has enough room for the power cord.
Doesn't have any carpeting that will obstruct ventilation openings.
Connecting the water
and the drain
[Running a test cycle]
Run a test cycle (Rinse+Spin) with
machine
small amount of laundary
Running a Calibration mode
(Refer to the following
description)
Installing your washer _17
(about 4~5 Towels)
Finish the
installation
2012-08-31 2012-08-31 12:36:20 12:36:20