Table of Contents
Advertisement
4. Using the 6 bolts (3/8 x 1-3/8 in.) and locknuts
(3/8 in.) supplied with the sulky, secure the axle and
the spacers as illustrated in Figure 5.
Note: You may have difficulty installing one of the bolts
on the right side due to interference with the traction
control lever. If this happens, disconnect the control rod
from the pistol grip (Fig. 6) to drop the lever out of the
way. When finished, reconnect the control rod.
3
Figure 6
1. Control rod
2. Clevis pin
Installing the Sulky
Assemblies
1. Slide the mounting tube on each sulky assembly over
the ends of the axle with the foot rests towards the
inside (Fig. 7).
2
3
4
Figure 7
1. Axle
2. Sulky assembly
2
1
4
m–5400
3. Pistol grip
4. Hairpin cotter
1
m-5479
3. Washer, 1-3/4 in.
4. Lynch pin
2. Secure the sulky assemblies using a washer (1-3/4 in.)
and lynch pin on each side (Fig. 7).
3. Grease the sulky; refer to Greasing the Sulky, page 8.
Adjusting the Handle Height
Because the sulky raises you several inches off of the
ground, adjust the handle height to accommodate you on
the sulky comfortably. Refer to your machine Operator's
Manual for more information on changing the handle
height.
Important
On a hydro drive, pistol grip machine, do
not use the highest handle position; use the middle
position. Using the highest position may damage the
controls.
Installing the Transport Hooks
1. Pivot the left sulky assembly up until it is near the
pulley guard (Fig. 8).
3
2
1
4
Figure 8
1. Transport hook
2. Toe guard
2. Position the hook over the toe guard on the sulky and
the eye end of the hook against the pulley guard
(Fig. 8).
3. Adjust the height of the sulky and the position of the
eye until it is in a clear location on the pulley guard,
both on the outside and inside of the guard, then tie the
sulky in place.
6
m-5486
3. Mark the location
4. Eye of the hook
Advertisement
Table of Contents
