Related Manuals for Toro Tru Trak Sulky 30110
Summary of Contents for Toro Tru Trak Sulky 30110
- Page 1 Form No. 3326-667 Tru Trak Sulky Proline Mid Size Mower Attachment Model No. 30110—210000001 and Up Operator’s Manual Domestic English (EN)
-
Page 2: Table Of Contents
Thank you for purchasing a Toro product. followed. All of us at Toro want you to be completely satisfied with Warning signals a hazard that may cause serious injury or your new product, so feel free to contact your local death if the recommended precautions are not followed. -
Page 3: Setup
Do not allow use of the sulky by untrained operators. Use caution when riding the sulky over curbs, rocks, roots, or other obstructions. Use appropriate personal protective apparatus for eyes, ears, feet, hands, and head. Slow down before making turns and use extra caution on rough terrain and on slopes. - Page 4 m–5483 Figure 3 1. Front holes (pistol grip 3. Rear holes (T–bar machines) machines) 2. Middle holes 4. Axle mounting bracket m-5473 Figure 2 Installing the Axle on a Gear Drive 1. Pulley guard 4. Locknut, 3/8 in. Machine with a T-bar Control 2.
- Page 5 m-5471 Figure 4 1. Pulley guard 5. Locknut, 3/8 in. m–5476 2. Axle mounting bracket 6. Bolt, 3/8 x 4-1/2 in. 3. Large spacer 7. Small spacer 4. Bolts, 3/8 x 1-3/8 in. 3. Remove the long bolt and nut securing the top of each pulley guard (Fig.
-
Page 6: Installing The Sulky Assemblies
4. Using the 6 bolts (3/8 x 1-3/8 in.) and locknuts 2. Secure the sulky assemblies using a washer (1-3/4 in.) (3/8 in.) supplied with the sulky, secure the axle and and lynch pin on each side (Fig. 7). the spacers as illustrated in Figure 5. 3. -
Page 7: Operation
If your machine is a gear drive, pistol grip machine, Important The sulky must be at least 1-1/2 in. you may need to adjust the wheel drive tension; refer (3.8 cm) from any contact point such as the machine to you machine Operator’s Manual. handle or the gear shift lever (when pushed to the right and left) on gear drive machines. -
Page 8: Maintenance
Maintenance Recommended Maintenance Schedule Maintenance Service Maintenance Procedure Interval 8 hours Check the tire pressure. 25 hours Grease all fittings. Grease all fittings. Check the tire pressure. Storage Service Paint chipped surfaces. Checking Tire Pressure Ensure that the caster wheel tires are filled with air to 50 psi (345 kPa) every 8 operating hours or before each use.