Handle Assembly - Elgee Power-Vac 632-E Owner's Manual

1.
Attach the Left and Right Handle Legs to the machine body. NOTE: The Right Handle Leg has five
holes and goes on the right side of the machine (when viewed from the operator's position); the
Left Handle Leg has only three holes and goes on the left side. For each leg, use two hex-head
machine screws, flat washers, and locking hex nuts as shown in the illustrations below.

Handle Assembly

(WHEEL NOT SHOWN FOR CLARITY)
RIGHT HANDLE LEG
5/16" X 1-1/2" HEX
HEAD SCREW (2)
5/16" FLAT WASHER (2)
5/16" LOCKING HEX NUT (2)
(WHEEL NOT SHOWN FOR CLARITY)
LEFT HANDLE LEG
5/16" X 1-1/2" HEX
HEAD SCREW (2)
5/16" FLAT WASHER (2)
5/16" LOCKING HEX NUT (2)
4