Elgee Power-Vac 632-E Owner's Manual page 12

1/4" LOCK WASHER
1/4" HEX NUT
3.
From the inside of the Hose Nozzle, pass a 1/4" x 1-1/4" hex head
machine screw through the hole nearest to one end of the Nozzle.
Secure the screw with a 1/4" lock washer and hex nut. Pass a 1/4" x
1" hex head machine screw through the other hole.
HOSE HANDLE
1/4" HEX NUT (2)
1/4" LOCK WASHER (2)
5.
Slide a hose clamp onto the Hose. Push the Hose
onto the Hose Nozzle and tighten the hose clamp
to secure it.
HEX HEAD MACHINE
SCREW, 1/4" x 1-1/4"
HEX HEAD MACHINE
SCREW, 1/4" x 1"
4.
Position the Hose Handle onto the two screws installed in Step
3 and secure with 1/4" lock washers and hex nuts. Some minor
distortion of the Hose Nozzle may occur as the fasteners are
tightened. This is normal.
HOSE HANDLE
HOSE NOZZLE
11
HOSE NOZZLE
HOSE
HOSE CLAMP
HOSE NOZZLE