Kenwood DDX9018S Instruction Manual page 59

Ñ
Learning function of steering
remote
This function is available only when your
vehicle is equipped with the electrical steering
remote controller.
If your steering remote controller is not
compliant, learning may not be completed
and error message may appear.
1
Touch [Steering Remote Controller] in
the User Interface screen.
h Steering Remote Controller Setting h
screen appears.
2
Press and hold the steering remote
controller button
NOTE
• You can have the unit learned all buttons
at a time. In that case, press the all buttons
one at a time and after pressing all of them,
touch [Learning completed] in Steering
Remote Controller Setting screen. However,
new functions cannot be learned after this
operation.
3
Touch the function you want to set.
4
Repeat steps 2 and 3 as necessary.
5
Touch [Learning completed].
NOTE
• When changing the function already learned,
press and hold the button you want to change
in step 2 and then touch to select the changed
function from the function list.
• Confirm the contents of the settable function on
the function list. You cannot edit the function list.
• To initialize the contents, touch [Learning
initialisation] of [Steering Remote
Controller] in User Interface screen. After you
touch [Initialise], a confirmation message
appears. Follow the message and complete the
operation.
Ñ
Register operations by Gesture
Control (
You can register operations that work by the
motion of your hand.
1
Touch [Gesture SETUP] on the User
Interface screen.
h Gesture SETUP screen appears.
h
2
Touch a gesture mark you want to set.
■ [Initialise]
Return to the initial setting. The confirmation
message appears. Touch [Yes].
3
Touch the function you want to set.
4
Repeat steps 2 and 3 as necessary.
5
Touch [
].
Setup
)
English
59