Getting Started - Cardo Systems FREECOM1+ Manual

2. GETTING STARTED

2.1 GETTING TO KNOW YOUR FREECOM 1+/2+
2.2 CHARGING THE FREECOM 1+/2+
Make sure that your FREECOM 1+/2+ battery is charged for at least 4 hours before initial use.
To charge the unit:
1. Using the supplied USB cable, connect your computer or wall charger to the USB port on your FREECOM
1+/2+.
Charging with the wall charger is faster than via a computer USB port.
●
Charging your unit switches it off automatically. To use your unit while it is being charged, switch it
●
on.(see Switching Your Unit On/Off on page 5).
While charging, the LED indicates the charging status as follows:
Red LED on — charging
●
Red LED off — charging complete
●
2.3 SWITCHING YOUR UNIT ON/OFF
To switch your FREECOM 1+/2+ on:
Press both and
●
The speaker plays an ascending tone and a voice message greets you.
The LED confirms your FREECOM 1+/2+ is on:
Normal and low battery — LED flashes blue three times.
●
Charging — LED flashes red and purple three times.
●
for 1 second.