Adjusting Airflow Direction - Panasonic S-22MK2E5A Operating Instructions Manual

Setting the airflow
direction
To activate the swing
operation
Heating
Set the flap (vertical airflow flap) to the downward
position. If the flap is set to the upward position, the
warm air may not reach the floor.
Initial setting
To stop the swing
operation

ADJUSTING AIRFLOW DIRECTION

The functions differ depending on the indoor unit used. The airfl ow direction cannot be set
using the remote controller for any unit which is not listed below.
Y2 type, K2 type:
• Never use your hands to move the fl ap (vertical airfl ow fl ap) that is controlled using
the remote controller.
• When the air conditioner is turned off, the fl ap (vertical airfl ow fl ap) automatically moves to
the downward position.
• The fl ap (vertical airfl ow fl ap) moves to the upward position when performing the standby
operation for heating. The swing operation is made after the standby operation for heating is
released, but swing is indicated on the remote controller even during the standby operation
for heating.
The airfl ow direction changes each time the
Press the FLAP button to set the fl ap (vertical airfl ow fl ap) to the downward position, and then
press the FLAP button again. This displays
down.
Cooling and drying
The flap (vertical airflow flap) can be
set to one of three positions.
Initial setting
Press the FLAP button again during the fl ap swing operation to stop the fl ap at the desired
position. Then, the airfl ow can be set from the top position by pressing the FLAP button again.
Indicator when swing operation is stopped
Fan and heating
During cooling or drying operation, the fl ap will not stop at the downward position. Even if the
fl ap is stopped at the downward position during the swing operation, it will not stop until it
moves to the third position from the top.
FLAP button is pressed during operation.
, and the airfl ow automatically swings up and
Fan operation
Initial setting
Cooling and drying
All operations
Continuous
operation
9