Simpson Clean Machine CM60912 Instruction Manual page 9

Connect Spray
4
Wand to Spray
Gun
Thread the spray
wand into the end
of the spray gun.
Release Air from
7
System
Release all
air from pump and
high pressure hose by
depressing trigger until a
steady stream of water is
present. Approximately
30 seconds.
Pull the Recoil
10
Starter Grip
Pull the
recoil starter grip to
start the engine.
WARNING: This Guide is not a substitute for reading the operator's manual. User
must read and understand operator's manual before using this product.
Connect QC
5
Nozzles to Spray
Wand
Pull quick connect
coupler back and insert
nozzle. Release quick
connect coupler and
twist nozzle to make sure
it is secure in coupler.
Verify the
8
Engine Switch
is turned to the
ON Position
Push the Choke
11
Pin in to the
RUN Position
Gradually move the
Choke Pin to the
RUN Position after
engine starts.
9 - ENG
Turn Water
6
Faucet
Completely On
Do not run the unit
without water supply
connected and turned on.
Use Cold Water Only.
Verify the Choke
9
Pin is pulled out
to the CHOKE
position
The Choke Pin has been
preset by the factory to
be in the CHOKE Position.