Simpson Clean Machine CM60912 Instruction Manual page 11

E. Quick-Connect Spray Wand: Allows the user to quickly change out
high pressure nozzles. See How To Use Spray Wand instructions in
Operation section.
F. Detergent Tank: Feeds cleaning agents into the pump to mix with the
water. See How To Apply Chemicals/Cleaning Solvents instructions in
Operation section.
G. Handle
H. Frame
J. Pump Outlet
K. Pump Inlet
L. Quick Connect Nozzles
M. Nozzle Chart Label
N. Handle Knob
P. Thermal Relief (not shown)
Q. Filter Screen (not shown)
R. Trigger Lock (not shown)
S. Cleaning Tool (not shown)
T. Water Source (not shown)
BASIC ELEMENTS OF AN ENGINE
Refer to the Engine Owner's Manual for location and operation of engine controls.
Choke Control: Opens and closes carburetor choke valve.
Starter Grip: Pulling starter grip operates recoil starter to crank engine.
Engine Switch: Enables and disables ignition system.
1. Locate and remove all loose parts from the carton.
2. Cut four corners of the carton from top to bottom and lay the panels flat.
3. Place one hand firmly on the handle (G), place the other hand on the knob (N)
on the right side of the handle. With the hand on the knob on the right side of
the handle, carefully pull knob back and gently pull the handle upward until fully
locked in place.
FIG. 2
G
N
NOTICE: Risk of personal injury. Avoid placing hands between handle and frame
when assembling to prevent pinching.
4. Remove the colored quick-connect nozzles (L) from the plastic bag and insert
them into correct grommet on the nozzle holder. Nozzles are color coded to
match colored nozzles on label (M).
5. Connect wand (E) to gun (D). Tighten securely.
ASSEMBLY INSTRUCTIONS (FIG. 2–4)
11 - ENG
FIG. 2A
L
M