To avoid potential shorts in the electrical
system, be sure to disconnect the(-) bat
tery cable before installation. Use this unit
with a 12-Volt battery and negative ground
ing only. Failure to do so may result in a
/
this product. To avoid short-circuiting, cover any disconnected leads with insulating
tape. It is especially important to insulate any unused wires, which if left uncovered
may cause a short circuit. When connecting other devices to this product, refer to
the manual for the product to be connected. T he black cable is ground, make sure
to metal parts of the vehicles body frame or direct to the battery if your vehicle
does not have a grounded chassis frame The ground wire of this units power amp
and a second powered system must be connected to the frame separately with
Route strap
around the speaker body to vehicle frame
CAUTION/!
A
Mounting straps should be double checked to be sure they are
pulled tight and secure before each use of the vehicle.
ALLEN HEAD
BOLT
SNAP
BRACKET
ALLEN HEAD
BOLT
LEFT
or
RIGHT
' z
s >
t
l
s >
FOR ILLUSTRATION PURPOSES
YOUR VEHICLE MAY VARY
TOOLS NEEDED:
- Wrench or Pliers
- Allen Wrench
LOCKNUT
Z-BRACKET
LOCKNUT
WASHER
HANDLEBAR
CLAMP
RUBBER
SHIM