Advertisement
INFORMATION TO THE USER
FCC COMPLIANCE STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause Interference, and
this device must accept any interference, including interference that may cause
(2)
undesired operation of this device.
This transmitter must not be co-located or operated in conjunction with any other
antenna or transmitter. The Bluetooth antenna cannot be removed (or replaced) by
user. This equipment compiles with FCC/ IC radiation exposure limits set forth for
an uncontrolled environment and meets the FCC radio frequency (RF} Exposure
Guidelines and RSS-102 of the IC radio frequency (RF} Exposure rules. This
equipment has very low levels of RF energy that it deemed to comply without
maximum permissive exposure evaluation (MPE}. But it is desirable that it should
be installed and operated keeping the radiator at least 20 cm or more away from
person's body (excluding extremities: hands, wrists, feet and ankles}. Alteration
or modifications carried out without appropriate authorization may invalidate the
user's right to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are de
signed to provide reasonable protection against harmful interference In a residen
tial installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions. may
cause harmful interference to radio communications. However, there is no guar
antee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user Is encouraged to try to
correct the interference by one or more of the following measures:
□ Relocate or reorient the receiving antenna.
□ Increase the separation bet w een the equipment and receiver.
□ Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
□ Consult the dealer or an experienced radio/TV technician for help.
CAUTION/I
A
ADJUSTMENT OR ALTERATIONS OF THIS DEVICE MAY RESULT
IN HAZARDOUS RADIATION EXPOSURE.
BEFORE YOU START
C IMPO RTANT SAFETY PRECAUTIONS
■ Do not operate mobile equipment while driving a motorized vehicle - safe driving and
safety consideration of olhers should always be your highest priority.
■
In the event you should notice smoke, strange noises or odor from this product, or any
off
other abnormal signs, immediately tum
the power and consult your dealer or the near
est authorized
BOSS AUDIO
Service Center. Using this product in this condition may result
in penmanent damage to the system.
■ Set your volume control at a low setting, then slowly increase the sound until you can
hear it comfortably without distortion, or ear discomfort.
■ BE SURE
TO
OBSERVE THE FOLLOWING GUIDELINES:
- Do not tum up the volume so high that you can't hear what's around you.
- Use caution or temporarily discontinue use in potentially hazardous situations.
(
IN_ S
_
T
A
LL
A
_
T
IO
N
____
_
_
_
_
PROFESSIONAL INSTALLATION RECOMMENDED.
■ Do not allempt to service this product by yourself. Servicing of this product by persons
without professional training and experience in electronic equipment andmotorized vehicle
accessories may be dangerous and could expose you to the risk of electric shock, injury or
other hazards.
■ Contact BOSS Audio Systems for any Installation, service questions or requests
L
can be powered from a vehicles cigarette lighter/ auxiliary power port, or
■
The
A TV95
RGB
hard wired d i rectly to the battery through an optional relay I accessory switch
When wiring directly to the vehicles ballery, be sure lo disconnect the batteries negative
■
terminal wire before starting any wiring procedures, it is suggested that an optional fuse
and fuse holder (not included) with minimum rating of
ballery terminal
■ The ground cable length should not exceed 18-inches (See wiring diagram)
■
The
A TV95LRGB
has a weather resistant design, it should not be submerged under water
under any circumstances
■ Use only the Installation parts provided with the
• Ensure the
MFC
is not mounted behind metal
■ Do not Install the
next to the vehicles electronics
MFC
■
Never install this product in a heated location
A
CAUTION/I Using other mounting methods may void this wa"anty
)
R_
E
CA
U
TI
O
N_ s
)
P
_
____
_
_
_
_
_
_
be in line with the positive
20 Amps
ATV95LRGB
Advertisement
