Advertisement
20' x 20' Pinnacle Setup Instructions
Check to make sure you have all parts required
Parts List
Box 1 of 4
Tent Top
4 Ratchet Buckle Straps (1") 4 Rope Ratchet Locks
Box 3 of 4
4 Alum 8' Legs
4 Alum 15" Spreader Inserts
1 Center Mast Top Pin
8 Steel Anchoring Pins
1)
Lay out a drop cloth in the area the tent will be installed.
a.
Drop Cloth Sold Separately, not included in tent package.
2)
Lay out all parts in their respective positions forming a square on top of the drop cloth.
3)
Start in the middle of one side by connecting both ends of the 15" spreader insert to each of the 9'3" spreader
tubes. Continue this until all four sides are completed (See Diagram: I).
4)
Starting at a corner, insert the spreader tube (9'3" connected tube) into the corner fitting.
5)
Continue to insert all spreaders into the corner fittings until a square is formed.
6)
Connect one cross cable to the inside hook on the corner fitting. Connect the other end of this cable to the hook
on the corner fitting at the diagonal corner.
7)
Connect the second cross cable to the remaining two corner fittings in the same way
a.
In order to fit the cable onto the 4th corner fitting hook, you may need to lift the frame up in that corner
approximately 4 feet. This reduces the distance between the corners allowing the cable to reach the 4th
corner fitting hook (See Diagram: III).
8)
Lay the tent top out over the cables and frame with the top of the tent facing upward. Start in one corner by
securing the white nylon strap over the ring on the outside of the corner fitting (See Diagram V).
9)
Continue to secure all the tent corner straps to the outside corner fittings. Make sure that the strap with the ring
on it is the last one to be secured. You will use this ring and strap when securing the top over the last fitting.
10)
Once the top is in place and secured, you're ready to install the legs. Lift one side of the tent up and install the
legs (8') at each corner, leaving the tent at an angle (See Diagram: VI).
Box 2 of 4
2 Cross Cables
4 Corner Fittings
4 Base Plates
Box 4 of 4
8 Alum 9'3" Spreaders
1 Alum Center Mast Pole
Page 5 of 6
Advertisement
