Bradford White D Series Service Manual page 12

7. Software Version (Display only)
8. Error Code History (Displays if there are present error codes or up to 10 previous error codes). Water Heater Display
will show a "--" if there are no error codes.
WARNING
Setting the water temperature
to the maximum set point can
result in scalding hot water
delivered to the faucets. It is
highly recommended that the
maximum setpoint be adjusted
to the lowest temperature
possible for the needs of the
installation. Make sure the
water heater control display is
not in a public area that can
re su lt in t h e t emp era t ur e
set ti ngs bei ng improp erly
adjusted.
To change the Maximum Setpoint Limit (Max Setpoint) for the temperature setpoint:
Step 1: In service mode press the "Select" button until "Max Setpoint" is displayed.
12
Soft
idle
Status Operational
SELECT SET
idle
Status Operational
SELECT SET
Max
°F
Setpoint
idle
Operational
Status
SELECT SET
Page 12
Troubleshooting