Advertisement
4.
To lay tiles on the floor:
a. Position Level in a corner so
that laser lines run parallel to the
reference lines as shown in Step 3.
b. Lay the first tile so that the sides are
flush with the 0° and 90° laser lines.
c. If laying next to an edge, position
the Level so that the T-Edge is
against the side of the edge.
The 90° laser line should run
parallel to the edge and the 0°
laser line marks the tile row.
0°
Floor
5.
To apply tiles to a wall:
a. Determine the height at which
the first tile row should begin and
mark the wall using the ruler on the
Level or other measuring device.
b. Place the T-Edge at the mark and
straighten the Level so that the 0°
laser line is parallel with the floor.
90°
0°
t-Edge
on mark
Page 6
reference
90°
Wall
reference
reference
reference
For technical questions, please call 1-888-866-5797.
6.
To check the alignment of a row of tiles,
place L-Edge at the corner of a tile.
0°
7.
To check the alignment of a single
tile, place the Level's edge on
top of the tile as shown below.
90°
8.
When finished with the Level, press
the Power Switch to turn it OFF.
Store Level in a dry indoor area
away from children, If storing for a
long period, remove the batteries.
0°
Item 57932
Advertisement
