Advertisement
Operating instructions
read the EntirE iMpOrtant SaFEty inFOrMatiOn section
at the beginning of this manual including all text under
subheadings therein before set up or use of this product.
General Operation
1.
Install batteries as described in
"Battery Replacement" on page 7.
2.
Set the Level on a flat, level surface.
3.
To mark guidelines:
a. Place the bottom on the Level on
the floor or wall. Press the Power
Switch to turn on the laser.
b. Place the T-Edge against a
wall so that the laser lines run
parallel to reference lines.
0°
reference
Item 57932
reference
90°
For technical questions, please call 1-888-866-5797.
c. If on the wall, align the Level so
that the 0° Alignment Bubble
is level and the 90° Alignment
Bubble is at the top.
d. If on the floor, align the Level so that
both Alignment Bubbles are level.
Page 5
Advertisement
