Advertisement
TROUBLESHOOTING
Problem
The vacuum cleaner
will not start
The vacuum cleaner is
not charging
The suction power is
decreasing
Vacuum cleaner is
over heating
The air coming out of
the vacuum cleaner
smells
The battery/charging
indicator light is blinking
The brush does not turn
anymore
PRODUCT SPECIFICATIONS
Model
Power Source
Motor
Adaptor (Input)
Adaptor (Output)
Type of Battery Used
Charging Time
Power Consumption
Operation temperature
Product dimensions
* The final product specification may be varied according to a different lot of
material and actual input voltage power of the usage area.
Possible cause
The vacuum cleaner has
not been charged
The power switch is not
turned on
The power cord is
damaged
The crevice tools or
extension hose may be
blocked
Water in the reservoir is
very dirty
Filter is dirty
Filter is dirty
Filter is dirty
Filter is not dry
The vacuum cleaner is
out of power
The brush has
encountered too much
resistance
: GWC25V
: 25.2V Rechargeable Battery
: DC 25.2V
: AC 100-240V 50/60Hz
: DC 32V 400mA
: Li-ion Battery, 2000mAh
: 6 - 8 Hours
: 130 Watt
: 0˚C to 40˚C
: 260(W) x 1105(H) x 263(D) mm
Make sure the vacuum cleaner has been fully
charged for first time use or if it has not been used
for a long time.
Make sure the power switch of main power supply
is turned on.
Do not use a damaged power cord. Please bring
to customer service centre.
Check that there are no blockages in the crevice
tools and/or extension hose. If so, clear the
blockages before using.
Change the water in the reservoir to fresh water.
Clean the filter. It is recommended to replace
the filter one time per year to maintain maximum
performance.
Check the filter and clean off any dirt.
Check the filter and clean off any dirt.
Make sure the filter has been left to dry before
inserting it back into the handheld unit.
Recharge the vacuum cleaner to its full capacity.
The light will stop blinking.
Clean the brush
21
Solution
Advertisement
