Table of Contents
Advertisement
CAUTION!
In the absence of electricity
you can ignite the burner
without electrical device; in
this case approach the
burner with a flame, turn the
control knob counter-
clockwise to maximum gas
supply position and push it
down. Keep the control
knob pushed for equal or
less than 10 seconds to let
the thermocouple warm up.
If the burner accidentally
goes out, turn the control
knob to the off position and
try to light the burner again
after minimum 1 minute.
The spark generator can
start automatically when you
switch on the mains, after
installation or a power cut. It
is normal.
The hob is supplied with the
progressive valves. They
make the flame regulation
more precise.
4.3 Turning the burner off
To put the flame out, turn the knob to
the off position
5. HINTS AND TIPS
WARNING!
Refer to Safety chapters.
5.1 Cookware
CAUTION!
Do not use cast iron pans,
potstones, earthenware, grill
or toaster plates.
WARNING!
Do not put the same pan on
two burners.
.
WARNING!
Always turn the flame down
or switch it off before you
remove the pans from the
burner.
4.4 Using the wok stand
The wok stand lets you use a round
bottomed wok on the hob. Use the wok
stand on the Triple Crown Triple Crown
burner only. When you refit the wok
stand, make sure the recesses on the
frame fit securely to the bars of the pan
supports.
When you refit the grate of
the Triple Crown burner,
make sure to match the
hollow part of the grate with
the reference located on the
plate fixed to the glass.
WARNING!
Do not put unstable or
damaged pots on the burner
to prevent from spill and
injury.
CAUTION!
Make sure that the bottoms
of pots do not stand above
the control knob, otherwise
the flame heats the control
knob up.
ENGLISH
9
Advertisement
Table of Contents
