Troubleshooting - Electrolux EW2TN5061C User Manual

24 www.electrolux.com
3. Remove the drain hose from the rear
support and unhook it from sink or
spigot.
4. Put the ends of each drain and inlet
hose in a container. Let the water
flow out of the hoses.
5. Set the
and let it operate until the end of the
cycle.
6. Turn the programme knob to position
Zap./Vyp.
appliance.

14. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
14.1 Alarm Codes and Possible failures
The appliance does not start or it stops during operation. First try to
find a solution to the problem (refer to the tables).
WARNING!
Deactivate the appliance before carrying out any
check.
With some problems, the acoustic signals operate. The red indicator
of the button Start/Pauza flashes and one of the phase indicators
comes on, to show an alarm code:
Problem
The appliance does
not fill with water
properly.
Vypouštění programme
to deactivate the
Possible solution
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not too
low. For this information, contact your local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the inlet hose has no kinks, damages or
bends.
• Make sure that the connection of the water inlet hose is
correct.
• This problem may be caused by the filter of the inlet hose
or by the clogged drain circuit. Please contact the Author‐
ised Service Centre.
• Make sure that the filter of the inlet hose and the filter of
the valve are not clogged. Refer to 'Care and cleaning'.
7. Disconnect the appliance from the
mains socket.
WARNING!
Make sure that the
temperature is more than
0°C before you use the
appliance again. The
manufacturer is not
responsible for damages
caused by low temperatures.