Consumption Values - Electrolux EW2TN5061C User Manual

26 www.electrolux.com
Problem
You cannot open the
appliance lid.
The appliance makes
an unusual noise and
vibrates.
The programme du‐
ration increases or
decreases during
programme execu‐
tion.
The washing results
are not satisfactory.
Too much foam in
the drum during the
washing cycle.
After the check, activate the appliance. The programme continues
from the point of interruption.
If the problem occurs again, contact the Authorised Service Centre.
The necessary data for the service centre is on the rating plate.

15. CONSUMPTION VALUES

15.1 Introduction
See the web link www.theenergylabel.eu for
detailed information about Energy Label.
Possible solution
• Make sure that a washing programme that ends with water
in tub, has not been selected.
• Make sure that the washing programme is finished.
• Set the drain or the spin programme if there is water in the
drum.
• Make sure that the appliance receives electrical power.
• This problem may be caused by a failure of the appliance.
Contact the Authorised Service Centre.
• Make sure the levelling of the appliance is correct. Refer
to "Installation instruction".
• Make sure that the packaging and/or the transit bolts are
removed. Refer to "Installation instruction".
• Add more laundry in the drum. The load may be too small.
• The AutoSense System is able to adjust the programme
duration according to the type and the laundry load size.
Refer to "The AutoSense System load detection" in "Daily
Use" chapter.
• Increase the detergent quantity or use a different deter‐
gent.
• Use special products to remove the stubborn stains before
you wash the laundry.
• Make sure that you set the correct temperature.
• Decrease the laundry load.
• Reduce the quantity of detergent.