Care And Maintenance; General Information; Cleaning The Control Panel; Cleaning The Door Glass - Lamona LAM3407 Instructions And Installation

Built-in single fan oven
Table of Contents

Advertisement

Care and maintenance

General inf
ormation
Service life of the product will extend and the
possibility of problems will decrease if the product
is cleaned at regular intervals.
Risk of electric shock!
Switch off the electricity before cleaning appliance
to avoid possibility of an electric shock.
Hot surfaces may cause burns!
Allow the appliance to cool down before you clean
it.
• Clean the product thoroughly after each use.
This way it will be possible to remove cooking
residues more easily and will avoid burning them
on the next time the appliance is used.
• No special cleaning agents are required for
cleaning the product. Use warm water with
washing liquid, a soft cloth or sponge to clean the
product and wipe with a dry cloth.
• Always ensure any excess liquid is thoroughly
wiped off after cleaning and any spillage is
immediately wiped dry.
• Do not use cleaning agents that contain acid or
chloride to clean the stainless steel surfaces and
the handle.
Use a soft cloth with a liquid detergent (not
abrasive) to wipe those parts clean, paying
attention to sweep in a horizontal direction.
The surface may be damaged by some
detergents or cleaning materials.
Do not use aggressive detergents, abrasive
cleaning powder/cream or any sharp objects.
Do not use steam cleaners for cleaning.

Cleaning the control panel

Clean the control panel and control knobs with a
damp cloth and wipe them dry.
Do not remove the control knobs for control panel
cleaning.
Cleaning the Oven Door
Don't use any harsh abrasive cleaners or sharp
metal scrapers for cleaning the oven door. They
could scratch the surface and damage the glass.
Removal of the Oven Door
1. Open the door.
2. Unlock the clips at the hinge housing on the right
and left hand sides of the door by pressing them
down as illustrated in the diagram.
1. Door door
2. Clips
3. Oven
4. Raise the door to the half-way position.
5. Remove the door by pulling it up-wards to slide it
from the hinges.
Steps carried out during removing process should
be performed in reverse order to reattach the door.
Do not forget to close the clips at the hinge
housing when reinstalling the door.
LAMONA Appliances
Page _ 18

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents