Table of Contents
Advertisement
Before the 1st washing
The washing machine was inspected thoroughly before leaving
the factory. To remove any water left over from testing
procedures, the first washing cycle should be carried out without
laundry in the machine.
The washing machine must have been installed and connected
²
properly. See chapter Installing ~ Page 53
Check the machine.
1.
Never switch on a damaged machine. Inform your customer
²
service. ~ Page 42
Remove protective film from the fascia.
2.
Insert mains plug.
3.
Turn the tap on.
4.
Switch on the appliance.
5.
Close the washing machine door. Do not load any washing.
6.
Select the Cottons programme.
7.
Select the temperature 90 °C.
8.
Open the detergent drawer.
9.
Pour approx. 1 litre of water (1¾ pt) into dispenser II.
10.
Add standard detergent to dispenser II according
11.
to manufacturer's instructions for light soiling.
To prevent frothing, use only half the recommended amount
²
of detergent. Do not use any standard or mild detergents.
Close the detergent drawer.
12.
Select Start/Reload
13.
When the programme ends, switch off the appliance.
14.
Your washing machine is now ready for use.
.
Ü
55
Advertisement
Table of Contents
