Table of Contents
Advertisement
7.8.
Removing the DV-Board
1. Remove the DG-Board with DV-Board. (See 7.7.)
(See above figure in item 7.7.)
2. Remove a fixing screw (
3. Disconnect the coupler (DV15-DG10) and remove the DV-
Board.
7.9.
Removing the AP-Board
1. Remove the rear AV bracket ass´y (See 7.4.) and the rear
metal frame. (See 7.5.)
2. Disconnect the couplers (AP2, AP6 and AP10 (AC Cord))
and the bridge cables (H1 (AP1) on the H-Board, P3/CN201
(AP3) on the P-Board and DG4 (AP4) and DG5 (AP5) on
the DG-Board.
3. Remove the fixing screws (7pcs).
4. Remove the AP-Board.
) (reverse side).
TX-32LX500M / TX-32LX500A / TX-32LX500X / TX-26LX500M / TX-26LX500A / TX-26LX500X
7.10. Removing the H-Board
1. Remove the rear AV bracket (See 7.4.) (and the rear metal
frame). (See 7.5.)
2. Disconnect the flexible cables (H2 and H3), the bridge cable
(H1) and the couplers (H4, H5, H6, H8 and H9).
3. Remove the fixing screws (4pcs).
4. Remove the H-Board.
7.11. Removing G-Board bracket (G-
Board and GP-Board)
1. Remove the rear AV bracket (See 7.4.) and the rear metal
frames. (See 7.5.)
2. Remove the fixing screws (2pcs
AV bracket slightly.
3. Disconnect the flexible cable (GP10) and the couplers (G1,
G4, G5, G10, G11 and GP6).
4. Remove a screw on the DG-Board and release the earth
lug from the DG-Board.
5. Release the cables from the cable holders of the G-Board
bracket.
6. Remove the G-Board bracket with the G-Board and GP-
Board.
17
) and pull out the rear
Advertisement
Table of Contents
