Installation - RCF HDL18-AS Owner's Manual

Two aluminium die cast handles with rubber hand-grip are available on each side of the
speaker system.
The outdoor quality, Baltic birch plywood, cabinet is protected with heavy duty, scratch
resistant, polyurea coating.
WARNING: never suspend D LINE speakers by there handles. Handles are intended for
transportation, not for rigging.
WARNING: always make sure that the maximum current requirement does not exceed
the maximum admitted POWERCON current. In case of doubt call the closest RCF service
centre.
MAINS SUPPLY
The system accept mains supply voltage115-230 (+15/-15%) V ~
- 230 VOLT, 50 Hz SETUP
- 115 VOLT, 60 Hz SETUP:
- Suspending loads should be done with extreme caution.
- When deploying a system always wear protective helmets and footwear.
- Never allow people to pass under the system during the installation process.
- Never leave the system unattended during the installation process.
- Never install the system over areas of public access.
- Never attach other loads to the array system.
- Never climb the system during or after the installation.
- Never expose the system to extra loads created from the wind or snow.
WARNING: The system must be rigged in accordance with the laws and regulations of the
Country where the system is used. It is responsibility of the owner or rigger to make sure that
the system is properly rigged in accordance with Country and local laws and regulations.
WARNING: Always check that all the parts of the rigging system that are not provided from
RCF are:
- appropriate for the application;
- approved, certified and marked;
- properly rated;
- in perfect condition.
8
: FUSE VALUE T 1.6 A - 250V
FUSE VALUE T 3.15A - 250V
TRANSPORTATION

INSTALLATION

WARNING
WARNING
HDL18-AS SUSPENDED
WARNING
WARNING