Page 2
F6168110V Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER...
Page 3
F6168110V Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER THANK YOU FOR YOUR PURCHASE Thank you for purchasing this quality product. To ensure correct function and safety, please read and save all instructions before using the product SAFETY TIP To avoid possible electric shock, turn off...
Page 4
F6168110V Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER Blade screws(10PCS) Mounting screws (2PCS) Screws(2PCS) Plastic wire nut (4PCS) Washer (2PCS) Mounting bracket 8’’ Ball/downrod assembly REMOTE CONTROL(1PCS) Canopy Decorative cover Coupling cover Blade(3 PCS) Fan-motor assembly Lower motor housing...
Page 5
F6168110V Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER Outlet box washers...
Page 6
F6168110V Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER Use wire connecting nuts supplied with the fan FROM POWER SOURCE AC 110- 120 VOLT 60Hz BLUE BLUE WHITE AC IN N(WHITE) 3.5AMPS. WHITE WHITE BLACK AC IN L(BLACK)
Page 7
F6168110V Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER...
Page 8
F6168110V Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER...
Page 9
F6168110V Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER Remote controller GENERAL INFORMATION This remote controller is desianed to separatelv control vour ceilina fan speed and light on and off. There are four buttons(HI,MED, LoW,OFF) to control the speed of the fan and off.
Page 10
F6168110V Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER If other fans or supply wires are different color, have this unit installed by qualified licensed electrician. e.Push all connected wires up into junction box. f. Lay the brown antenna wire on top of the receiver, and put the receiver into the mounting bracket.
Page 11
F6168110V Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER size of product Ø6.1in Ø12.2in Ø52in...
Page 12
F6168110V Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER TROUBLESHOOTING GUIDE Table of Contents 1. Fan / Remote is not working 2. Fan is noisy 3. Fan Wobbles 4. Light is not working Please refer to the instruction sheet for detailed directions and descriptions of installation steps and requirements.
Page 13
F6168110V Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER 3. THE FAN WOBBLES Verify all blades and blade bracket screws are secure (most fan wobble problems are caused by loose parts). Once fan is properly installed, run the ceiling fan for 10 minutes to let the fan self-adjust.
Page 14
F6168110V Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER AFTER INSTALLATION WOBBLE” The fan blades have been adjusted in the factory to minimize any wobble NOTE:CEILING FANS TEND TO MOVE DURING OPERATION DUE TO THE FACT THAT THEY ARE MOUNTED ON A RUBBER CROMMET.
Need help?
Do you have a question about the F6168110V and is the answer not in the manual?
Questions and answers