Advertisement
Digital Wireless Receiver Module
A
CH.A
1
2
3
Operation
Power on and Off
1. Receiver module powers on along with the PA LCD displays On and after
to 2 seconds, screen displays channel number.
2. Receiver module powers off along with the PA, LCD displays Off, after 2 to 3
seconds the display shuts off.
Channel changing
1. Hold on SET key to enter channel changing mode, once the channel number on
the display starts to flash, you may use the up and down key to select channel.
2. After confirm the channel, press SET key again, or it also auto confirms without
pressing any keys for less than 10 seconds.
Operating range Hi/Low setting
1. In off mode, press SET key and power on the PA to enter the setting mode.
2. Now the screen flashes Hi or Lo, press up and down key to switch in between.
3. Press SET key again to confirm, or it also auto confirms without pressing any
keys for less than 5 seconds.
DIGITAL
B
CH.B
SET
4
5
3
1. LCD display
(channel number/
signal strength/
A channel battery meter)
2. A channel volume
3. Channel selection
4. Set key
5. B channel volume
,
,
1
Advertisement
