Adjusting The Color; Cleaning And Replacing The Air Filter; Saving And Recalling Picture Settings - Epson PowerLite Cinema 200 Product Information

Epson PowerLite Cinema 200 Projector

Adjusting the Color

You can use the Color Adjustment settings to fine-tune the
color of the image.
1. Select , then click
Picture Quality
2. Select one of the following modes, then click
❏
: Adjusts the offset, gamma, and gain for each signal
RGB
color. Use to adjust darker shades,
Offset
intermediate shades, and
❏
: Adjusts the hue and saturation for each of six
RGBCMY
colors, as shown on the color palette below. After moving
a slider bar, click
Apply
Adjust
the hue
(red,
green,
blue,
cyan,
magenta,
yellow)

Saving and Recalling Picture Settings

Once you've adjusted the picture to your liking, you can save
your settings in the projector's memory. Then you can use the
remote control (or Cinema Color Editor) to recall them for
future use. You can also rename or delete memory settings
stored on the projector.
1. Select , then click
Picture Quality
2. Click one of the following:
❏
to use a memory setting stored on the projector
Select
❏
to create a new memory setting
Register
❏
to change the name of an existing setting
Edit
See the User's Guide for details.
10 - Epson PowerLite Cinema 200 Projector
Adjustment of image
.
Adjust
Gamma
for the lightest shades.
Gain
.
Adjust the saturation
Memory management
Use these
settings to
select,
register, or
edit a
memory
setting

Cleaning and Replacing the Air Filter

Clean the air filter on the bottom of the projector after every
.
100 hours of use. If it's not cleaned periodically, it can become
clogged with dust, preventing proper ventilation. This can cause
overheating and damage the projector.
1. Turn off the projector and wait for the P power light to stop
for
flashing.
2. Unplug the power cord and disconnect any cables.
3. Turn the projector over. Then use a small vacuum cleaner
designed for computers and other office equipment to clean
the filter. If you don't have one, gently clean the filter using a
very soft brush, such as an artist's paintbrush.
If the dirt is difficult to remove or the filter is broken, replace
it. Contact your dealer or call Epson at (800) 873-7766 and
ask for part number
463-7766 for dealer referral.
4. If you need to replace the filter, release the tab and lift open
the cover.
.
5. Remove the old filter and replace it with a new one.
6. To replace the cover, insert the tabs and press down until the
cover clicks into place.
1/04
. In Canada, call (800)
V13H134A04