Advertisement
·
Install the faucet and drain to the lavatory according to the
manufacture's instructions.
·
Put the sealant around the back wall attached surface of
the lav evenly.
·
Carefully place the lavatory against the wall, so the
hanger bolts extend through the lavatory holes.
·
Level the lavatory.
·
Install the cap nuts and washers, and tighten until snug.
CAUTION: Risk of product damage.
overtighten the cap nuts.Overtightening may cause
damage to the product.
·
Clean the lavatory top.
Install the Plumbing
1. Install the drain in accordance with the manufacturer s
instructions.
CAUTION!
Make sure a watertight seal exists on all
basin drain connections.
CAUTION!
Provide access to the plumbing
connections for future plumbing maintenance.
2. Connect the hot and cold water supplies.
3. Open the hot and cold water valves, and check the supply
connections for leaks.
4. Run water into the basin, and check the drain connections
for leaks.
1196536-T01-A
·
·
·
·
·
Do not
·
Apply Silicone sealant
along this face
Nut
Washer
Offset Nut
Fig.#3
3
,
1.
2.
3.
4.
Fig.#4
4
-3-
Advertisement
