3. Do one of the following:
■
Select
You should reset the lamp timer only when you install a new projector lamp. See
page 56 for more information.
■
Select
■
Select
Component, Save Memory, Language, and Lamp Hours).
Customizing Projector Features
Use the settings in this section to adjust the image size and position, suppress on-screen text,
and select basic setup options.
Image Sizing
Before adjusting any of these settings, make sure you have already selected an appropriate
aspect ratio for the type of picture you're viewing (see page 27).
■ Overscan
Signal > Advanced > Overscan
For component video formats, this setting lets you see the edges of the image that are not
normally visible in the picture (see page 67). If you see interference when you set
Overscan
■ Position
Signal > Position
Note: This setting cannot be used with a signal input through the HDMI 1 or HMDI 2 port.
Use the arrow buttons to fine-tune the position of the image on the screen.
■
Aspect
Signal > Aspect
This setting lets you change the aspect ratio of your image, and works the same as
pressing the
46
Making Detailed Adjustments
to clear the lamp usage timer and reset it to zero.
Reset Lamp Hours
to clear all memory settings.
Reset Memory
to return all projector settings to their original defaults (except
Reset All
to
, try adjusting the
100%
button on the remote control. See page 27 for more information.
Aspect
as described below.
Position