Epson PowerLite 8300i Quick Manual page 14

5. If your network does not assign addresses automatically,
turn off and enter the projector's
DHCP
, and
Subnet Mask Gateway Address
Note: To enter numbers using the remote control, press the
button until it lights, then use the number keypad.
Num
6. After changing an address in the network menu, press the
button. This stores the value.
Enter
7. When done making all necessary changes, press
the menu system.
Registering Projectors in EMP Monitor
Before you can monitor a projector, you have to register it.
Follow these steps:
1. Open EMP Monitor by selecting
Start menu. You see this screen:
Click here
2. Click
Register projector
You see this screen:
3. Click to locate projectors currently operating
Auto detect
on the network. Or click
projector's name and network address.
IP Address
, as needed.
ESC
from the
EMP Monitor
as shown.
Click here
and enter the
Manual registration
Any projectors found on the network are listed as shown
, below:
to exit
4. Select the projectors you want to add by clicking their
name. Then click
You see your registered projectors listed on the main EMP
Monitor screen.
Monitoring Your Projectors
The EMP Monitor screen lets you monitor your projectors
using the Status, Video Source, and Error icons shown below.
This lets you see which projectors are currently being used,
from which source (or port) they are projecting an image, and
if a problem occurs.
Status icon
For detailed status information, select the projector in
question and click
Note: To monitor a projector when it's in standby mode (plugged
in but not projecting), you must have selected
Standby Mode
5/03
EPSON PowerLite 8300i Projector
, and on the next screen click
Add
Video Source icon Error icon
.
View details
setting in the projector's Advanced1 menu.
EPSON PowerLite 8300i Projector
Click here
.
Close
as the
Network ON
13
-