Get Started; Charge The Battery - Philips TAT4205 User Manual

3 Get started

Charge the battery

Note

place the headsets in the charging case and
charge the battery for 3 hours for optimum
battery capacity and lifetime.
 Use only the original USB Type-C charging
cable to avoid any damage.
 Finish your call before charging the headset,
as connecting the headset for charging will
Charging case
Connect one end of the USB Type-C
cable into the charging case, and
another end into the power source.
The charging case starts charging.
blue LED light on the charging case,
• When the charging case is fully
charged, the blue light goes on.
Tip
 The charging case serves as a portable backup
battery for charging the headset. When the
charging case is fully charged, it supports 3 full
recharge cycles for the headset.
Headset
Place the headset in the charging case.
The headset start charging.
LED light on the earpieces.
• When the headset is fully charged,
Tip
 Normally, a full charge takes 2 hours (for the
headset or charging case).
Pair the headset with
your Bluetooth device at
the rst time
Make sure that the headset is fully
charged.
Take both headsets out from the
charging case, the headset will
power on automatically, entering
pairing model and Right & Left
headset connected.
There will be a voice "Power on"
and a voice "Pairing". Then,LED
ashes in white and blue.