Table of Contents
Advertisement
Problem solving guide
Problem solving guide
What to do if, . . .
. . . the "Pre-wash", "Main
wash" or "Rinse 1-2" indicator
lamp is flashing?
. . . The "Rinse & hold" indica-
tor lamp is flashing?
. . . The "Final spin" indicator
lamp is flashing?
. . . The "ON" indicator lamp
is flashing?
. . . The wash is too wet after
the final spin?
. . . The machine shakes dur-
ing the spin cycle?
26
All manuals and user guides at all-guides.com
Cause . . .
There is an internal problem.
The spin speed selector has
been set to "Without final spin".
The final spin has not taken
place. The machine detected
an imbalance.
The child-safety feature is
activated, and the program has
been changed.
The spin speed selected was
too low.
The load was not evenly
distributed in the drum, and the
laundry was spun at a reduced
speed to protect the machine.
The drain pump or lint trap is
clogged.
The four feet are not resting
evenly on the floor.
The shipping struts have not
been removed.
Remedy . . .
Restart the program. If the
indicator lamp starts flashing
again, call the Service Dept.
Select a spin speed setting.
–
Redistribute the laundry load.
–
Select a spin speed.
–
Turn the program selector to
"Spin".
Go back to the program
originally selected.
Select a higher spin speed next
time.
Mix large and small items in a
load to avoid imbalance.
Clean the drain pump or lint
trap.
Level the machine (see
Installation Section).
Remove the shipping struts.
Advertisement
Table of Contents
