D-Link Exo AX DIR-X5460 User Manual page 70

Section 3 - Configuration
Status Enable or disable the DHCP server.
DHCP IP Address Enter the starting and ending IP addresses for the DHCP
Range server's IP assignment. Note: If you statically assign IP addresses
to your computers or devices, make sure the IP addresses are
outside of this range or you may have an IP conflict.
DHCP Lease Time Enter the length of time for the IP address lease in minutes.
Always Broadcast Enable this feature to broadcast your network's DHCP server
to LAN/WLAN clients.
WAN Port Speed You may set the port speed of the Internet port to 10 Mbps,
100 Mbps, 1000 Mbps, or Auto (recommended).
UPnP Enable or disable Universal Plug and Play (UPnP). UPnP
provides compatibility with networking equipment, software,
and peripherals.
IPv4 Multicast Streams Enable to allow IPv4 multicast traffic to pass through the router
from the Internet. This is enabled by default.
IPv6 Multicast Streams Enable to allow IPv6 multicast traffic to pass through the router
from the Internet. This is enabled by default.
D-Link DIR-X5460 User Manual
DHCP Server
Advanced Settings...
65